Auto Service Equipment
Personnel Lifts
Trailers
Special technics
Cranes
Containers and bunds
Gift ideasMulti-process welding inverter DECA EasyJob 220 LAB
The EasyJob 220 LAB is the ideal inverter Multi-process welding machine for any well-equipped garage or workshop.
This welding machine is ideal for professional craftsmen who need to use multiple welding methods for small repairs both indoors and outdoors.
EasyJob 220 LAB delivers 200 Amp direct current (DC).
The power supply voltage is single-phase 230 Volt. It has low energy consumption and can be used with reduced installed power (3 kW) or connected to a motor generator (see technical data table).
Extremely light and compact: It holds 100 / 200mm diameter wire spools.
EasyJob 220 LAB has 4 welding processes available: MIG/MAG, FLUX, MMA and TIG LIFT.
In MIG/MAG and FLUX mode, the EasyJob 220 LAB is perfect for welding steel, stainless steel, aluminum, and for the use of wire for brazing.
The change of polarity allows you to use a NO GAS cored wire. The cored wire has a substance inside that provides gaseous protection, making welding very simple without the need for a gas cylinder, particularly when working outdoors.
The Synergic control is extremely effective. All the main welding parameters are connected and act in a combined way to obtain a welding quality usually found in more sophisticated products.
The control panel is very simple to facilitate use in synergic and manual modes. The machine is pre-installed with a standard package of over 20 programs. An SD card can be used to update the software.
The TIG LIFT welding process, using a torch with a tap to control the protective gas, allows for minute processing on mild steel and stainless steel sheets of small thickness.
In TIG welding with LIFT arc striking, the tungsten electrode is placed on the surface to be welded and by lifting it slowly to strike the welding arc. The passage of low intensity current allows not to ruin the electrode while the welding machine progressively increases the amperage.
In electrode welding MMA EasyJob 220 LAB can be used with rutile and basic electrodes from 1.6 to 4.0 mm in diameter with excellent ignition properties and a stable arc. It is suitable for welding of mild steel and stainless steel.
Equipment: Torch DE M15A – 180A 3m (010583) (Tip Ø 0,8 mm), rollers (Ø 0,6 / 0,8 mm Fe), Cable 16mmq with ground clamp (2,7 m), gas hose (1,5 m).
Parameters
| Fuse | 25 A |
| Power supply | 1 Ph x 230V V/fāze |
| Electrode diameter | 1,6 - 4,0 mm |
| Sizes | 505 x 230 x 410 mm |
| Power | 6,0 kW |
| Welding current | 10 - 200 A |
| Duty cycles | MIG / MAG: (200A - 25%) - (140A - 60%) / MMA: (160A - 30%) - (130A - 60%) / TIG: (200A - 30%) - (140A - 60%) |
| Flux wire diameter | 0,9 - 1,2 mm |
| Wire diameter aluminum | 0,8 - 1,0 mm |
| Wire diameter steel | 0,6 - 0,8 - 1,0 mm |
| Weight | 15 kg |
| Open voltage | 85 V |
